FABRICATION OF LOW FREQUENCY PATCH ANTENNA WITH ADHESIVE COPPER TAPE

Authors

  • MR. P.C. DHANAWADE Assistant Professor, DKTE’S Textile and Engineering Institute, Ichalkaranji.
  • MR. V. M. DAVANDE Assistant Professor, DKTE’S Textile and Engineering Institute, Ichalkaranji
  • MR. V.B. SUTAR Assistant Professor, DKTE’S Textile and Engineering Institute, Ichalkaranji.
  • MS. P. S. MANE PG Student (Electronics), DKTE’S Textile and Engineering Institute, Ichalkaranji.

Keywords:

Patch, MATLAB, FR4

Abstract

 In this paper a very easy process of designing & fabricating Microstrip antenna with adhesive copper tape is presented. The rectangular structure is designed for 700MHz and it is modelled with High Frequency Structure Simulator (HFSS). The prototype is fabricated with FR4 material and 70 micron thick copper tape. The fabricated antenna is tested on Antenna Trainer Kit to observe radiation pattern.

Downloads

Published

2021-02-22

Issue

Vol. 3 No. 03 (2017): Journal Nx

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

How to Cite

FABRICATION OF LOW FREQUENCY PATCH ANTENNA WITH ADHESIVE COPPER TAPE. (2021). JournalNX - A Multidisciplinary Peer Reviewed Journal, 3(03), 10-12. https://repo.journalnx.com/index.php/nx/article/view/2217