DESIGN AND MANUFACTURING OF HAND INJECTION MOULDING DIE

Authors

  • Mr. Y. V. Shinde
  • Attar Aman Ramjan
  • Phadtare Poorva Tulsiram
  • Potekar Shashwat Dhanyakumar
  • Shingade Snehal Dadasob Department of Mechanical Engineering, Phaltan Education Society’s Collage of Engineering Phaltan , Maharashtra , India

Keywords:

Design Phase, Die Design, Tolerance and Fits, Cooling System Design, Manufacturing Phase, Assembly, Maintenance and Adjustments, Quality Control.

Abstract

This Project gives the information about to design and fabrication of injection Molding die for Production of washer by using Plastic material. For Increasing the Production rate,designing and manufacturing the multi cavity die and also using HDPE (High Density Polyethylene)to overcome the existing plastic material drawbacks.The injection molding die contains the core plate,top and bottom supported plates, channels or runners, sprue, vents ejector and its pins and horn pins,etc. The Greek word of “plastic’’meaning is ‘able to be shaped and molded’, in so many different plastic materials I am using High Density Polyethylene material for production of plastic washer components.

Downloads

Published

2021-07-31

How to Cite

Mr. Y. V. Shinde, Attar Aman Ramjan, Phadtare Poorva Tulsiram, Potekar Shashwat Dhanyakumar, & Shingade Snehal Dadasob. (2021). DESIGN AND MANUFACTURING OF HAND INJECTION MOULDING DIE. JournalNX - A Multidisciplinary Peer Reviewed Journal, 7(07), 142–146. Retrieved from https://repo.journalnx.com/index.php/nx/article/view/5451

Issue

Section

Articles

Similar Articles

1 2 3 4 5 6 7 8 9 10 > >> 

You may also start an advanced similarity search for this article.